We produce built Transformer Cores as a built up unit up to 50 MT

Manual & Handgrip Clamps

TSD 'STANDARD' SCREW CLAMPS.

The TSD standard screw clamps offer many possible uses. They are designed to be used in conjunction with ratchet lever hoists to align steel structures or fabrications. They are ideally suited for the construction industry.   
The unique design of the spindle makes it easy to attach to 'angle' plate. This is achieved by simply turning the handle which applies the pressure to the plate holding it securely.   
NB. The plate surface of the material to be lifted must not exceed a hardness level of HRC 30/Brinell 300.   

TSZ 'TWO WAY' SCREW CLAMPS.                                   

The TSZ 'two way' screw clamps have all the same features of the TSD (shown above) but have the additional benefit of a second lifting point enabling it to pull in two different directions.
NB. The plate surface of the material to be lifted must not exceed a hardness level of HRC 30/Brinell 300.


TSH 'SWIVEL HOOK' SCREW CLAMPS.                                   

The TSH 'swivel hook' screw clamps offer many possible applications. It is particularly useful for lifting, transferring and pulling sheet metal, girders and steel constructions.
The clamps are supplied complete with an alloy safety shackle, that allows for pulling in 180' degrees.
NB. The plate surface of the material to be lifted must not exceed a hardness level of HRC 30/Brinell 300.

TPZ BOARD CLAMPS.                                   

TPZ board clamps offer an simple and effective way to vertically lift and transport a variety of materials such as wood, MDF, plasterboard, stone, and plastics. They can also be used to lift loads from the horizontal to the vertical through 900 for transportation. The range has been designed to be user friendly and the handle enables the operator to guide the load easily during operation and each clamp is supplied fitted with large rubber pads to minimise damage.
These clamps are ideal in production facilities and especially on construction and building sites.

HGC HAND GRIP CLAMPS                                   

The HGC hand grip clamps are suited for the individual transport of light and thin plates. They have a jaw capacity of up to 10 mm and can lift up to 250kgs.
To operate the clamp you simply press down on the hand grip which compresses a spring. This allows the clamp to open and slide onto the plate. The plate can then be lifted and transported using the ergonomically designed hand grip. The positive spring pressure prevents the plate from accidentally slipping out of the clamp.
NB. Plate surface of material lifted must not exceed a hardness level of HRC 30/Brinell 300..                             

 

Contact Us

Follow us on Facebook

Copyright © 2013 KRYFS Manufacturers. All Rights Reserved.

SEND INQUIRY